Abstract
To recover measurement quickly after robot collision in robotic online visual measurement system, two simple and feasible methods to recalibrate the tool center point(TCP) of robot quickly are proposed. When there is a robot collision in the industry field, only several measurements are performed by moving the robot, then the tool coordinate is recalibrated and the robot TCP is recovered accurately, which can effectively avert the complex work of re-teaching the robot's measurement trajectory. The tool coordinate and TCP of the robot are defined in this paper first, based on the structure parameters of the light plane in visual sensor. Then the reference sphere based tool coordinate calibration method and common point deviation based calibration method are presented respectively. Simulation experiment testifies that the two methods can recover the robot tool coordinate and TCP quickly, and meet the demand of recovery measurement after robot collision in robotic visual measurement system.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.