Abstract
At the High Energy Beamline ID15A at the European Synchrotron Radiation Facility we have developed a fast three-dimensional x-ray microtomography system, which acquires a complete dataset in typically less than 10s. This unprecedented speed is achieved by combining a high efficiency phosphor screen, a reflecting microscope objective and a fast charge coupled device detector with the very intense high-energy white beam radiation provided by a wiggler source. The achieved spatial resolution is 2μm. The available x-ray energy spectrum spans from 20to250keV and can therefore be used for low and high Z materials. The spectrum can be modified by inserting different filters into the x-ray beam in order to optimize the signal-to-noise ratio and to avoid beam-hardening artifacts. Different phosphors with different energy sensitivity can be used. The very high speed allows in situ studies of systems evolving on the time scale of a few seconds or minutes. Three examples are given on sintering of metallic powders, solidification of binary alloys and liquid front propagation in granular materials.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
