Abstract
The mirror in the high-energy laser beam combining system needs to make a fast and high-precision pointing adjustment before working. A two-dimensional electrically controlled adjusting mirror was designed. The main body of the system adopted an integrated flexible support design, the drive adopted a stepping motor and a deceleration mechanism to drive the screw, the precision measurement of the mirror deflection angle adopted an eddy current sensor, and the digital signal processor (DSP) was adopted as the main control module. The working principle and design of the system were analyzed, and the system calibration method as well as the control algorithm were deeply studied. In order to meet the requirements of system adjustment speed, the S-shaped acceleration and deceleration algorithm was adopted as the control algorithm of adjusting mirror, and the system calibration method with piecewise linearity was adopted. Finally, the system was tested experimentally. The experimental results show that within the angle range of ±500″, the in-position time of adjusting mirror is within 3 s, and the control error is less than 2″, which can meet the system requirements.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
