Far-field reactivation of natural fractures by stress shadow effect

Abstract

Hydraulic fracturing is the most important means to achieve the reservoir stimulation of tight formations like shale, where the reservoir permeability is enhanced after the interaction between hydraulic fracture (HF) and natural fractures (NFs). Apart from the widely known direct intersection behaviors between HF and NFs (i.e., the HF meets the NFs), the NFs may also be reactivated by the stress shadow effect of HF, but the failure mechanism and reactivation modes are still unclear. To address this, the far-field reactivation of NFs under the stress shadow effect is described based on a hybrid phase field model (PFM) with the frictional contact criterion, where the open or slip conditions can be quantitatively calculated using the Mohr-Coulomb yield function along the contact interface of NFs. The zone with reactivated NFs is divided into mode II and mixed mode dominated sub-zones respectively, and the phase diagram of reactivation behaviors is summarized as variations of the location and angle of the NF. The NF reactivation modes are discussed under different geological conditions (strength of NFs, distribution angle of NFs, and initial stress difference). It could be found that the higher initial stress ratio leads to more mode II reactivated NFs, and NFs strengths and angles influence both mode II and mixed mode zones notably. The NF reactivation tends to take place with lower strength, higher injection rate, higher initial stress ratio, and special angle (e.g., HF are perpendicular to NFs), during which the permeability enhancement and reservoir stimulation are evaluated by the phase field model.