Fan-Out Wafer-Level Packaging (FOWLP) of Large Chip with Multiple Redistribution-Layers (RDLs)

Abstract

Abstract This study is for fan-out wafer-level packaging (FOWLP) with chip-first (die face-up) formation. The chips with Cu contact-pads on the front-side and a die attach film (DAF) on the backside are picked and placed face-up on a temporary glass wafer carrier with a thin layer of light-to-heat conversion (LTHC) material. It is followed by compression molding with epoxy molding compound (EMC) and post mold cure (PMC) on the reconstituted wafer carrier, and then backgrinding the molded EMC to expose the Cu contact-pads of the chips. The next step is to build up the redistribution layers (RDLs) from the Cu contact-pads and then mount the solder balls. Next comes the de-bonding of the carrier with a laser, and then the dicing of the whole reconstituted wafer into individual packages. A 300mm reconstituted wafer with a package/die ratio = 1.8 and a die-top EMC cap = 100μm has also been fabricated (a total of 325 test packages on the reconstituted wafer.) This test package has three RDLs; the line width/spacing of the first RDL is 5μm/5μm, of the second RDL is 10μm/10μm, and of the third RDL is 15μm/15μm. The dielectric layer of the RDLs is fabricated with a photosensitive polyimide (PI) and the conductor layer of the RDLs is fabricated by electrochemical Cu deposition (ECD).