Abstract

Adhesively bonded joints have been extensively employed in the aeronautical and automotive industries to join thin-layer materials for developing lightweight components. To strengthen the structural integrity of joints, it is critical to estimate and improve joint failure loads effectually. To accomplish the aforementioned purpose, this paper presents a novel deep neural network (DNN) model-enabled approach, and a single lap joint (SLJ) design is used to support research development and validation. The approach is innovative in the following aspects: (i) the DNN model is reinforced with a transfer learning (TL) mechanism to realise an adaptive prediction on a new SLJ design, and the requirement to re-create new training samples and re-train the DNN model from scratch for the design can be alleviated; (ii) a fruit fly optimisation (FFO) algorithm featured with the parallel computing capability is incorporated into the approach to efficiently optimise joint parameters based on joint failure load predictions. Case studies were developed to validate the effectiveness of the approach. Experimental results demonstrate that, with this approach, the number of datasets and the computational time required to re-train the DNN model for a new SLJ design were significantly reduced by 92.00% and 99.57% respectively, and the joint failure load was substantially increased by 9.96%.

Full Text
Published version (Free)

Talk to us

Join us for a 30 min session where you can share your feedback and ask us any queries you have

Schedule a call