Abstract
A method for accurately predicting the strength of multifastener, thick composite joints is discussed. The method is based on the average stress criterion applied around the hole circumference. Basic laminate strength data are obtained from single-fastener and reduced-section notched specimens. Using ABAQUS finite element analyses (FEA), the stress-field distribution around the fastener-loaded hole in both the single-fastener and multifastener joints is determined. The single-fastener test data in conjunction with this FEA and the average stress criterion are then used to predict the multifastener joint strength. Multifastener joint strength of three different laminate lay-ups is predicted to within 1% accuracy. However, the results show that the average stress criterion cannot accurately predict the location of failure initiation. In the current investigation, the maximum strain criterion is used to locate possible sites of failure initiation. When this information is used in conjunction with the average stress criterion, the predicted multifastener joint strength based on single-fastener net-tension data is reasonably accurate.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
