Abstract
Cr8Mo2SiV cold work die parts cracked early during machining process. In order to find out the reason of cracking failure of the die parts, the macro crack analysis, chemical composition analysis, hardness test and microstructure analysis of the parts were carried out by stereo microscope, direct reading spectrometer, digital Vickers hardness tester, metallographic microscope and scanning electron microscope. Some results are obtained: the chemical composition of cracked parts was tested and found similar to Cr8Mo2SiV, compared with standard Cr8Mo2SiV, it contains 3.81%W, and its hardness is 229 HV1, means that the cracked parts are not hardened. By observing the micro morphology of the crack, there are oxide and decarburization layer on the crack surface of the parts. It proves that the crack was formed before spheroidizing annealing. It is a typical raw material crack.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
