Abstract
The present study is about the failures of tubes from a tube shell heat exchange in one of the compression stages used to cool and purify the gas produced in an off-shore platform. Conventional hydrostatic tests did not detect leaking in the heat exchanger, but these tests were conducted at room temperature, i.e., very distant to the service temperature (163°C). However, tightness tests with helium gas have detected leaking. Some tubes were taken off for analysis and the liquid penetrating test detected cracks in crevices formed between the tube and the tube sheet. The cracks were found to be typical stress corrosion cracks with branched pattern. A non-destructive test with Eddy current probes was developed to give high percentage of detection. The work was conclusive about the main cause of failures. Due to the increase of chloride content of the water processed to concentrations higher than 1000mg/L over the years, the substitution of AISI 321 tubes by superduplex steel is recommended.
Sign-in/Register to access full text options 
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
