Factors influencing the release of potentially toxic elements (PTEs) during thermal processing of electronic waste

Abstract

The release of potentially toxic elements as airborne fine particulates is a significant environmental risk associated with recycling e-waste. Some of these may redeposit near emission sites or be transported over long distances causing wide-spread pollution. With an aim to identify key factors affecting particulate emissions, we report novel investigations on the adsorptive capture of particulate matter (PM) released during low temperature pyrolysis (600 °C; 15 min) of waste printed circuit boards (PCBs). A significant proportion of the released particulates (5.3 to 37%) were captured by adsorbents located downstream and in close proximity to the emitting source. Data was collected for four different PCBs and three adsorbents: alumina, silica-gel and activated carbon. With sizes ranging from nanoparticles to over 10 µm, adsorbed particulates were present as fines, spheres, oblongs, clusters and larger particles with no specific shape. Of the 24 elements identified initially in waste PCBs, only 14 were detected in released particulates: major PTEs— Zn, Sn, Pb and Cu (up to 400 ppm); minor PTEs— Ni, Mn, Cd, Cr and Ba (up to 10 ppm); trace PTEs— Co, In, Bi, Be and Sb (up to 1 ppm). Key factors influencing the release of PTEs during thermal processing were identified as basic elemental characteristics, densities, melting points, vapor pressures, initial concentrations, local bonding and mechanical strength. These results show that the presence of low melting point/high vapour pressure elements (Zn, Pb, Sn) should be minimised for a significant reduction in PTE emissions during e-waste processing.