Factors governing the flow lineation of a large-scale pyroclastic flow — An example in the ata pyroclastic flow deposit, Japan

Abstract

Schmincke andSwanson (1967) explained laminar flowage structures as indicators for flow direction of pyroclastic flows that show a radial flow pattern away from the source. Several other authors have reported similar examples, but the influence of pre-flow topographic relief has not been analyzed. Flow lineations were measured for the Ata pyroclastic flow deposit, southwestern Japan. This deposit has covered an undulating basement topography. Preferred orientation of crystals and lithic fragments were measured on thin sections cut parallel to sedimentary layering. The following three factors which control the flow lineation have been recognized. 1) Flow lineations oriented radially away from the source, as described by previous authors, were obtained only for samples collected from the surface of the pyroclastic flow plateau where the basement valleys were nearly filled by earlier flow units. 2) Lineations near the floor of narrow valleys were parallel to the strike of the valley. 3) Flow lineations near the wall of valleys tend to be parallel to the dip of the valley walls. These data suggest that the initial radial movement of pyroclastic flows from the source gradually changes direction to parallel the strike of deep valleys due to confining effect of valley wall. Flows which are trapped within a valley, tends to move towards the bottom of the valley just prior to the final settlement. After the basement topographic relief has been filled up with earlier flow units, the later flows maintain their original radial movement until final settlement.