Factors determining degree of inflation in intratracheally fixed rat lungs.

Abstract

The total lung capacity (TLC) of rats was measured in vivo and was compared to the displacement volume of the lungs following intratracheal fixation with glutaraldehyde or formaldehyde solution. When glutaraldehyde was used the speed of infusion of the fixative was an important factor in the final degree of lung inflation achieved. With a low rate of fixative infusion and a final pressure of 20 cm of fixative the glutaraldehyde-fixed lungs inflated to 55% TLC. With a high initial flow of glutaraldehyde and a final pressure of 20 cm of fixative the lungs inflated to 84% TLC. Fixation of lungs inside the intact chest wall was found to result in a higher degree of inflation. With a reservoir height of 20 cm and a low rate of fixative infusion lungs fixed in situ reached 74% TLC, whereas lungs fixed in situ, but from animals that have been exsanguinated prior to fixation, inflated to only 58% TLC. This suggests that the volume of the blood in the lungs prior to infusion of glutaraldehyde influences the degree of inflation achieved. Formaldehyde-fixed lungs required 72 h to be completely fixed and they were inflated to 90% TLC when a reservoir height of 20 cm was used. Because of the slow rate of fixation using with formaldehyde solution the rate of infusion was found not to limit the degree of inflation that could be achieved.