Abstract
The influence of dressing of the abrasive tool and the table’s direction on the final surface roughness Ra in deep grinding of titanium alloys by a silicon-carbide wheel is investigated. Formulas are derived by dispersional analysis of Ra measurements over the length of the blank.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
