Abstract
AbstractProcedures for the manufacture of thin wall ceramic components from particulate suspensions using plastic forming methods which employ extensional flows are described. These include vacuum forming, blow moulding and film blowing. In order to understand how to select materials and to adjust the composition of such suspensions, the factors which control suspension rheology are identified. The measurement of extensional viscosity of ceramic suspensions is reported and compared with shear flow measurements.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
