Facile synthesis and characterisation of Mn0.5Zn0.5Fe2O4/Fe2O3 as a novel nanocomposite for studying analytical parameters affecting on photocatalytic degradation of basic fuchsin dye

Abstract

ABSTRACT Restricted biodegradability, toxicity, and carcinogenicity of basic fuchsin dye are the principal reasons that motivate scientists to find methods to remove it. Photocatalytic degradation technology is simple, environmentally friendly, inexpensive, efficient, and does not yield secondary pollution. Most of the catalysts used to degrade basic fuchsin dye require expensive chemicals to prepare. Therefore, the novelty in our work comes from the utilisation of low-cost chemicals for the facile synthesis of Mn0.5Zn0.5Fe2O4/Fe2O3 nanocomposite using the pechini sol-gel method. The synthesised samples at 300, 600, and 900°C were encoded as F300, F600, and F900, respectively. The XRD confirmed that the average crystallite size of the F300, F600, and F900 samples is 95.08, 122.32, and 160.21 nm, respectively. Hence, as the calcination temperature increases, the crystallite size increases as a result of coagulation that occurs at higher temperatures. The FE-SEM images showed that the F300, F600, and F900 samples consist of spherical, (polyhedral and spherical), and (hexagonal and spherical) shapes with an average diameter of 258.64, 470.12, and 625.32 nm, respectively. This change in morphology at different temperatures is due to the discrepancy in the rate of liberation of organic matter at different temperatures. In the presence of hydrogen peroxide, 0.05 g of the Mn0.5Zn0.5Fe2O4/Fe2O3 nanocomposite degrade 100% of 25 mL of 25 mg/L of basic fuchsin dye at pH = 8 within 25 min. Consequently, the other side of the novelty of our work is the ability of the synthesised nanocomposite to effectively degrade a high concentration of the basic fuchsin dye in a short time.