Abstract
A simple method was developed for the large-scale fabrication of mechanically durable superhydrophobic surfaces with roughness on the microscale. The method is applicable for a large number of fibrous substrates with different pore sizes. With this method, it is possible to prepare polymeric fibrous substrates with a water droplet (5 μL) roll-off angle of less than 5°. The method developed is based on dip-coating of fibrous substrates in polydimethylsiloxane (PDMS)/toluene solution, followed by the electrostatic spray of aerogel microparticles on the samples. Depending on the PDMS solution concentration, it is possible to obtain a superhydrophobic surface with dual-scale roughness on the microscale. In this article, preparation and characterization of surfaces with electrostatic powder spray on the common fibrous cellulose substrates are provided. Fibrous surfaces obtained were characterized by scanning electron microscopy, energy-dispersive X-ray spectroscopy and static water contact angle measurement. Effects of PDMS/toluene solution concentration on the surface morphology and wettability behavior of surfaces were investigated. We demonstrate the mechanical durability of the surface using high-pressure air flow.
Sign-in/Register to access full text options 
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
