Abstract
We demonstrate the cost-effective and facile method of fabricating close-packed microlens arrays using photoinduced two-dimensional (2-D) surface relief structures as original templates. 2-D surface relief structures are produced by successive inscription of two beams interference patterns with different grating vectors on azopolymer films. The employed exposure dose of 1st inscription stage and 2nd inscription stage are optimized to obtain symmetrical modulation heights. These photoinduced 2-D surface relief structures on azopolymer films are used directly to mold PDMS, and PDMS molds were then transferred onto photopolymer to imprint microlens arrays. Using this method, tetragonally and hexagonally close-packed microlens arrays are successfully fabricated in rapid and cost-effective way.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
