Facile and efficient fabrication of carbon nanotube reinforced epoxy vitrimers through dynamic crosslinking

Abstract

AbstractCarbon nanotubes (CNT) is an ideal candidate for reinforced epoxy vitrimer composites, however, achieving a desirable improvement of the mechanical properties is a great challenge owing to CNT is extremely easy to aggregate. In this study, well‐dispersed CNT reinforced epoxy vitrimers, namely EVD/CNT, were prepared by combining ultrasonic dispersion and dynamic crosslinking techniques, using multiple wall carbon nanotube as reinforcement filler, sebacic acid as curing agent, diglycidyl ether of bisphenol A (DGEBA) as epoxy monomer, zinc acetylacetonate as transesterification catalyst, torque rheometer (internal mixer) as dynamic crosslinking equipment. The CNT reinforced epoxy vitrimers, namely EVS/CNT, were prepared using traditional static curing method. The structure and morphology, mechanical properties and stress relaxation behavior of EVS/CNT and EVD/CNT were comparatively investigated, and the influence of CNT content on the structure and properties of EVD/CNT prepared by dynamic crosslinking method were also studied. The results indicated that dynamic crosslinking technology can stably disperse CNT into epoxy vitrimer resin matrix under continuous shear force. However, CNT experienced severe secondary agglomeration during the static curing process. When the loading amount of CNT was 2 wt%, the tensile strength and elongation at break of EVD/CNT‐2 were 3.2 times and 2.2 times higher than those of EVS/CNT‐2, respectively. The Young's modulus and glass transition temperature (Tg) of EVD/CNT‐2 (6.43 ± 1.10 MPa, 29.6°C) were also higher than those of EVS/CNT‐2 (5.46 ± 0.31 MPa, 25.4°C). Moreover, dynamic crosslinking technology greatly shortened the reaction time of CNT reinforced epoxy vitrimers, improved production efficiency and reduced reaction energy consumption, and was expected to be used for large‐scale and industrial production.