Fabrication, structural, morphological, and mechanical behaviour of fly ash doped clay ceramics based CO2 gas sensor

Abstract

Various attempts have been made to fabricate fly ash-doped clay composites via solid state reaction method. Additionally, to investigate the structural, mechanical, surface morphology, and CO2 gas sensing behavior, the fabricated clay composites were sintered at three different temperatures 1000, 1100, and 1200 °C (COF1, COF2, COF3) for 4 h. The green and sintered densities of the fabricated composites were found to be in the range of 2.17–2.13 g cm−3 and 1.38 to 1.30 g cm−3. Further, various characterization techniques such as x-ray diffraction (XRD), Fourier transform infrared spectroscopy (FTIR), Raman spectroscopy, universal testing machine (UTM) and scanning electron microscopy (SEM) with energy-dispersive x-ray spectroscopy (EDAX) were carried out. Moreover, to determine the compressive strength and Young’s modulus values, a universal testing machine (UTM) was used. The fracture toughness of the fabricated composites, COF2 and COF3 were found to be 7.84 MPa-m1/2 and 2.22 MPa-m1/2. The COF3 composite exhibited a sensing response, response time, recovery time of 3.39 at 1200 ppm CO2, 16.95 s and 18.05 s respectively. Consequently, this porous clay composite can be fabricated in a cost-effective and eco-friendly manner, hence beneficial for CO2 gas sensing applications.