Abstract
Self-switching diode (SSD) is a unipolar two-terminal planar device which has a typical channel in nanoscale dimension. It has shown outstanding properties as a microwave and submillimeter wave rectifier by exploiting its nonlinear current-voltage (I-V) characteristic and intrisically low parasitic capacitance. In detection systems, SSDs are often used with an antenna to form a rectifying antenna (rectenna). The large impedance mismatch between SSD and antenna, due to high resistance of a single SSD, has always hampered the rectenna to achieve good extrinsic rectification performance (e.g., voltage responsivity > 400 V/W). As such, a large array of SSDs connected in parallel is very much desired to reduce the device resistance, and hence minimizing the impedance mismatching issue. In this work, an interdigital structure which can accommodate approximately 2,000 SSDs in parallel has been utilized. The material used was InGaAs/InAlAs heterostructure grown onto an InP substrate. The fabrication of the SSD array has implemented an electron-beam lithography (EBL) technique and the use of polymethyl methacrylate (PMMA) as a masking layer. The fabricated SSD array has shown a typical diode-like I-V characteristic, indicating that EBL method is not only convenient to realize nanoscale electronic devices, but also very practical for large area operations.
Published Version
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
