Abstract
Engineering of TiO2 photoanode is an important strategy for increasing the photovoltaic conversion efficiency of quantum dots-sensitized solar cells (QDSSCs). In this work, three-dimensional ordered macroporous (3DOM) TiO2 films are fabricated by the controlled infiltrating-calcination method using the close-packed polystyrene spheres colloidal crystals as templates. The as-prepared macroporous TiO2 films are then applied as the photoanode in colloidal CdSe QDSSCs. This structure not only facilitates the penetration of thioglycolic acid capped CdSe QDs, and thus achieving a high coverage of the internal surface with QDs sensitizer, but also exhibits a photonic band gap with tunable positions, which could enhance the light absorption. As a result, the liquid-junction QDSSCs assembled with the CdSe sensitized 3DOM TiO2 yields a power conversion efficiency of 3.60% under solar illumination of 100 mW cm-2, and this value is much higher than that of the device using nanoporous TiO2 photoanode (1.82%). Our results indicate that the 3DOM TiO2 is a promising candidate for the construction of high-efficiency QDSSCs.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
