Abstract
Superconducting/normal metal bilayers with tunable transition temperature are a critical ingredient to the fabrication of high performance transition edge-sensors (TES). Popular material choices include Mo/Au and Mo/Cu, which exhibit good environmental stability and provide low resistivity films to achieve adequate thermal conductivity. The deposition of high quality Mo films requires sufficient adatom mobility, which can be provided by energetic ions in sputter deposition, or by heating the substrate in an e-beam evaporation process. The bilayer T c depends sensitively on the exact deposition conditions of the Mo layer and the superconducting/normal metal interface. Because the individual contributions (strain, crystalline structure, contamination) are difficult to disentangle and control, reproducibility remains a challenge. Recently, we have demonstrated that low energy ion beam assist during e-beam evaporation offers an alternative route to reliably produce high quality Mo films without the use of substrate heating. The energy and momentum delivered by the ion beam provides an additional control knob to tune film properties such as resistivity and stress. In this report we describe modifications made to the commercial end-Hall ion-source to avoid iron contamination allowing us to produce superconducting Mo films. We show that the ion beam is effective at enhancing the bilayer interface transparency and that bilayers can be further tuned to reduced T c and higher conductivity by vacuum annealing.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have