Abstract
Fabrication of quasi solid state dye sensitized solar cell with a stable gel electrolyte employing poly(ethylene oxide) (PEO)-poly(ethylene glycol) (PEG) is reported in this paper. PEO-PEG with either one of alkali iodides (LiI or NaI or KI), 1,2-dimethyl-3-propyl imidazolium iodide (DMPI), 4-tertbutylpyridine (TBP) and iodine in acetonitrile were used for the gel electrolyte preparation. The ionic conductivity and the triiodide diffusion coefficient of the gel electrolytes were measured by Electrochemical Impedance Spectroscopy. The photoconversion efficiency of gel state DSSC with NaI was found to be 5.4% at 100mW/cm2 with AM 1.5 Gfilter. When nanocrystalline TiO2 was used as the filler in the gel electrolyte, the photoconversion efficiency was found to be increased up to 6.3%. The quasi solid state DSSC retained its initial value for 600hours aging under ambient conditions.
Sign-in/Register to access full text options 
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
