Abstract
We fabricated single flux quantum RS flip-flop circuits by using ramp-edge Josephson junctions and tested their performance. The junctions were constructed with two Y/sub 1/Ba/sub 2/Cu/sub 3/O/sub 7-x/ (YBCO) electrodes and a barrier layer. As barrier materials we used cobalt-doped YBCO. To insulate between YBCO layers we used Sr/sub 2/AlTaO/sub 6/ (SAT) thin films. We also fabricated RS flip-flop circuits by using YBCO ground planes to reduce the inductance of YBCO film. The fabricated Josephson junctions showed typical RSJ-like current-voltage (I-V) characteristics above 50 K. We could successfully demonstrate the correct operation of the RS flip-flop circuits at the temperatures near 50 K. We used a computer controlled digital measurement set-up to test the circuits. The RS flip-flop circuit fabricated on a ground plane showed more definite set and reset states on the voltage-flux (V-/spl phi/) modulation curves of the read SQUID than those of the circuit made without ground plane. This may be attributed to the shielding effect by a YBCO ground plane.
Sign-in/Register to access full text options 
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
