Abstract
To date, there have been few reports of the fabrication of hardened, pure calcium carbonate specimens beginning from the powder state. In this study, hardened calcium carbonate bodies exhibiting high densities and compressive strengths were produced using a warm press method. The warm press conditions consisted of temperatures from 150 to 280°C and a uniaxial pressure of 240MPa, applied for durations of 10–180min to powder compacts composed of pure calcium carbonate powder or powder mixed with 10% water (by mass). Heating at 150°C and 240MPa for 180min with 10% water generated a relative density of 87% and an average compressive strength of 40MPa. The added water was found to play an important role to promote a solution-precipitation process inside the calcium powder compact, allowing low temperature sintering to form dense calcium carbonate.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.