Abstract
Porous geopolymers (PG) are attractive due to their simple fabrication and diverse applications. This work presents a method for fabricating PG by using aluminum salt slag (ASS) as a foaming agent and metakaolin (MK) as the precursor. Sodium silicate (Na2SiO3) and sodium hydroxide (NaOH) are used as alkali activator solutions. The results show that the PG is fabricated by using the sequence mixing method. ASS was milled to a size of 4 µm, then mixed with an NaOH solution for 30 min. After that, MK and Na2SiO3 solution were added. The weight ratio of Na2SiO3/NaOH and solid/liquid was 2.0 and 0.6, respectively. The 7-day cured PG with 5 wt% ASS achieves a strength of 15 MPa, which is close to the minimum requirement of Portland cement of 19 MPa. PG strength decreases, while setting time and pore size increase with increasing ASS content. The knowledge of this work enables the utilization of ASS as a valuable geopolymer foaming agent.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.