Abstract
A polarization control device was developed using a plasmonic metasurface with the aim of achieving the desired polarization state. In this study, the Ag metal grating structure was fabricated as a plasmonic metasurface by electron beam lithography and a lift-off process. The phase difference of the fabricated sample was 21.0°. This value is almost consistent with the simulation (24.0°). Then, the transmission and phase difference is dependent on the structural parameter. Because of the propagation of surface plasmon polariton at the interface between Ag and SiO2 or Ag and air, it is believed that the transmittance and the phase difference for TM polarized light can be controlled by the structural parameters. By plotting on the Poincaré sphere after calculating the S-parameter by simulation, it is clear that the arbitrary polarization status can be controlled by the structural parameter.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
