Abstract
The low temperature fabrication of passive electrical components (conductor, capacitor) on the flexible polymer substrate is presented in this paper. A drop-on-demand (DOD) ink-jetting system was used to print gold nano-particles suspended in Alpha-Terpineol solvent and PVP in PGMEA solvent to fabricate passive electrical components on flexible polymer substrate. Short pulsed laser ablation enabled finer electrical components to overcome limitation of inkjet process. Continuous Argon ion laser was irradiated locally to evaporate carrier solvent as well as to sinter gold nano-particles. In addition, a self alignment technique for PVP layer was demonstrated taking advantage of the deliberate modification of surface wetting characteristics. Finally, a new selective ablation of multilayered gold nanoparticle film was demonstrated using the ablation threshold difference for sintered and non sintered gold nanoparticles.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.