Abstract
Metallurgical solid waste blast furnace water quenched slag (WBFS) was employed as carrier materials to prepare Fe–TiO2/WBFS composite photocatalyst using a sol-gel method for improving both the photocatalytic activity and the high-value utilization of metallurgical solid waste. The Fe3+ doping technology was adopted to increase the utilization of solar energy. The influencing factors and photocatalytic activity were systematically evaluated by thermogravimetry/differential thermal analyser (TG-DSC), X-Ray Diffraction (XRD), Brunauer-Emmett-Teller (BET) method, scanning electron microscopy-energy spectrometer (SEM-EDS), X-ray photoelectric spectroscopy (XPS), UV–Vis absorption spectrum and photoluminescence spectra technology through the degradation rate of methylene blue (MB) solution. The results showed that the Fe3+ ions were successfully incorporated into the TiO2 lattice, which had no effect on the crystalline phase of TiO2 and expanded the spectral response range of TiO2 from the ultraviolet region to the visible light region. When the calcination temperature was at 450 °C and the number of Fe–TiO2 sol loading cycles was two times, the photocatalytic activity of Fe–TiO2/WBFS presented the strongest, and the degradation ratio of MB reach the maximum value of 98.9 %. A uniform and dense anatase TiO2 thin film was wrapped on the surface of WBFS. The photocatalytic activity first improved and then weakened with an increase of calcination temperature, Fe3+ doping amounts and the loading cycles of sol. The TiO2 film changed from thin to thick and uneven to uniform, until cracking and spalling phenomenon finally occurred with an increase of Fe–TiO2 sol loading cycle from 1 to 3 times. When the Fe–TiO2/WBFS was reused for four times, the degradation rate of MB could still show 67.4 %, being far higher than that of TiO2/WBFS of 25.4 %.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.