Abstract
In this work, α-Fe2 O3 photoanode consisted of (110)-oriented α-Fe2 O3 single crystals were synthesized by a facile hydrothermal method. By using particular additive (C4 MimBF4 ) and regulation of hydrothermal reaction time, the Fe-25 consisted of a single-layer of highly crystalline (110)-oriented crystals with fewer grain boundaries, which was vertically grown on the substrate. As a result, the charge separation efficiency and photoelectrochemical (PEC) performance of Fe-25A (Fe-25 after dehydration treatment) have been greatly improved. Fe-25A yields a photocurrent of 1.34 mA cm-2 (1.23 V vs RHE) and an incident photon-to-current conversion efficiency (IPCE) of 31.95 % (380 nm). With the assistance of cobalt-phosphate water oxidation catalyst (Co-Pi), the PEC performance could be further improved by enhancing the holes transfer at electrode/electrolyte interface and inhibiting surface recombination. Fe-25A/Co-Pi yields a photocurrent of 2.67 mA cm-2 (1.23 V vs RHE) and IPCE value of 50.8 % (380 nm), which is 3.67 times and 2.39 times as that of Fe-2A/Co-Pi. Our work provides a simple method to fabricate highly efficient Fe2 O3 photoanodes consist of characteristic (110)-oriented single crystals with high crystallinity and high quality interface contact to enhance charge separation efficiencies.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.