Fabrication of focused poly(vinylidene fluoride-trifluoroethylene) P(VDF-TrFE) copolymer 40–50 MHz ultrasound transducers on curved surfaces

Abstract

Copolymer films such as poly(vinylidene fluoride-trifluoroethylene) P(VDF-TrFE) have lower acoustic impedance compared to their ceramic counterparts, allowing for a better acoustic match to tissues in the human body. Because of this, copolymer ultrasonic transducers are capable of yielding the desirable characteristics of broad bandwidth and short pulse duration that allow better image resolution to be achieved. In the past, such transducers in the frequency range from 40 to 80 MHz have frequently been fabricated by spin coating the copolymer film onto a flat substrate and then applying the film to a curved backing using an adhesive layer. The adhesive layer may cause spurious signals at these frequencies, in addition to the film damage that may occur as a result of such processing. In order to avoid these problems, a copolymer film can be directly spin coated onto a curved substrate. The resulting devices had an operating frequency of over 40 MHz and approximately a 75% bandwidth. The potential of several approaches that could be further explored to increase the level of performance of such devices is also discussed.