Fabrication of dye-sensitised solar cell using dry Ixora extract as sensitiser

Abstract

ABSTRACT A dye-sensitised solar cell was fabricated using dry Ixora flower extract. The sensitiser was obtained by physical extraction using a mixture of ethanol and distilled water as solvent in the ratio of 7:3. The optical study of the sample was done within wavelength range of 230 nm to 1100 nm using spectrophotometer (UV- 750 series). The outcome shows an optimum absorption in the visible region of the EM spectrum, which shifted to the UV region when adsorbed onto a nano-porous TiO2 surface. An alternative peak of 0.95a.u in the visible region was observed with enhanced optical absorption across the infrared region of the spectrum. The absorption coefficient values suggest the extract absorbs light in the visible region, which was also confirmed with the relatively high extinction coefficient observed in the visible region of the EM spectrum. The extract exhibits a low transmittance in the visible range, which increases to over 99% in the red wavelengths. The extract has low reflectance of about 20% in the visible range, which falls lower as wavelength increases into the infrared region. The energy band gap (for direct transition) of 2.13 eV was obtained for dry Ixora dye extract. The fabricated solar cell performed a fill factor of 0.27, Jsc of 0.1273 mA/cm2, Voc of 0.7001 V, and conversion efficiency of about 0.02%. with these results, the dye extract of dry ixora flower can serve as a good photo-sensitiser for the fabrication of dye-sensitised solar cell.