Fabrication of Dual-pore Scaffolds Using a Combination of Wire-Networked Molding (WNM) and Non-solvent Induced Phase Separation (NIPS) Techniques

Abstract

In this study, to fabricate dual-pore scaffolds with interconnected pores, Non-solvent Induced Phase Separation (NIPS) and Wire-Network Molding (WNM) techniques were combined. First, a mold with uniform slits was prepared, and needles were inserted into the mold. Subsequently, polycaprolactone (PCL) pellets were dissolved in tetrahydrofuran (THF) at a specified ratio. The slurry was mixed using hot plate stirrer at 1200 rpm for 24 hours at 40 °C. The PCL slurry was subsequently injected into the mold. Thereafter, to exchange the THF (solvent) with the ethanol (non-solvent), the mold was soaked in an ethanol bath. After removing the mold from the ethanol bath, the needles were removed from the mold. Consequently, dual-pore scaffold with interconnected pores was obtained. The surface morphology of the fabricated scaffolds were observed using Scanning Electron Microscope (SEM). Moreover, cell culture experiments were performed using the CCK-8 assay, and the characteristics of cells grown on the dual-pore scaffolds were assessed and were compared with the NIPS-based 3D plotting scaffold.