Abstract
Direct bonding of diamond and Cu was successfully conducted by the surface activated bonding method at room temperature. The structure of the diamond/Cu bonding interface was investigated by transmission electron microscopy and electron energy-loss spectroscopy. The effect of heat treatment temperature on the interface structure was also investigated. A 4-nm-thick damaged layer was formed at the as-bonded interface, and the damaged layer’s thickness decreased with an annealing temperature rise. It was found that the atomic ratio of sp2 bonding in the bonding interface was larger than that of the diamond separated from the interface by approximately 50 nm, which indicates that the damaged layer was composed of amorphous carbon or graphite and diamond. After annealing at 700 °C, a composite layer about 2 nm thick was observed at the interface. There were no nano-voids or micro-cracks observed at the interface with annealing at a temperature as high as 700 °C. These results indicate that the diamond/Cu bonding interface has high thermal stability and can withstand the temperature rise of power devices during operation.
Sign-in/Register to access full text options 
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
