Abstract
Al–2 wt.% Mg–Re foams with relatively small pore size (∼1 mm) were fabricated by the melt foaming method with the addition of titanium hydride as a blowing agent. The corrosion resistance properties of the Al–Mg–Re foams have been studied and the results compared with those of Al foam and Al–5 wt.% Cu foam. The results show that in order to get Al–Mg–Re alloy foams with good pore structures, Ca and Mg should be added to the pure Al melt before adding the blowing agent; the corrosion resistance properties of Al–Mg–Re foams are better than those of Al foam and Al–Cu foams.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.