Fabrication of a ZnO piezoelectric cantilever with a high-aspect-ratio nano tip

Abstract

This paper reports the fabrication process of a ZnO piezoelectric micro cantilever with a high- aspect-ratio (HAR) nano tip for the scanning probe microscopy (SPM). The HAR nano tip has 5 /spl mu/m side length, over 15 /spl mu/m height, and less than 30nm tip radius, which is built on the cantilevers with 200/spl mu/m and 300/spl mu/m length. The designed resonance frequency and spring constant of cantilever with 300/spl mu/m length are 28.41kHz and 0.6986N/m, respectively. To prevent the distortion of data by the cantilever, the HAR nano tip is fabricated using deep RIE process and LPCVD poly-Si deposition. These steps protect nano tips during the whole process and minimize tip damage. To compensate residual stress, the multi-layered structure is used. It is composed of silicon nitride and poly silicon which have tensile and compressive stresses, respectively. And, to prevent ZnO breakdown and metal oxidation during anodic bonding process, internal metal patterns are isolated from the pyrex glass. After the boding process, they are connected with external electrodes through the via holes in pyrex glass.