Fabrication of a removable partial denture combining conventional and digital techniques

Abstract

This article describes a combined conventional and digital workflow for fabricating removable partial dentures (RPDs). After scanning the dental cast and RPD framework assembly, artificial teeth and denture base regions were designed using computer-aided design software. The artificial teeth and denture base assembly was milled as a single structure by using a wax disk and then placed on the RPD framework. The artificial teeth were additionally milled from a polymethyl methacrylate disk. Conventional procedures were followed for denture investment until the wax elimination procedure, after which the assembly was replaced with the artificial teeth in the cope of the flasks, and the denture resin material was injected to process the RPD. This technique enabled the RPD to be fabricated in the same form as the design state.