Abstract
This paper presents a novel LIGA-like process to fabricate the nozzle plate for matching the requirements of the 600 dpi inkjet printhead. This novel fabrication technique reduces the production cost from 100% current process to 50%. This mass production technique comprises two main technologies: Ni-Co electroforming and plastic injection molding. The nozzle plate consists ink channels, ink cavities, and nozzles for enhancing the integrity and excusing the assembly process. The dimensions of nozzle plate are 4.16mm in width and 7.3mm in length, respectively. Total thickness of micro-nozzle plates are thickness≦100um(ink channels and ink cavities), and the diameter and pitch of the nozzle holes are 40±3um and 168±3 um, respectively. Straightly speaking, for being the main compositions of the 600 dpi inkjet printhead design, the above fabrication process is qualified enough and capable of yielding satisfactory results.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
