Fabrication by photoinitiated polymerization and characterization of millimeter‐size poly(divinyl benzene) hollow foam shells

Abstract

ABSTRACTIn this study, millimeter‐size compound droplets were prepared easily by a one‐step microfluidic method. We varied the diameter and wall thickness of the shells over a wide range by setting the flow rate. Poly(divinyl benzene) (PDVB) shells with a 3–4.8 mm diameter were fabricated through photopolymerization and supercritical drying. The gel point of photopolymerization was monitored by a rotational rheometer. Moreover, the influence of the oil‐soluble photoinitiator phenyl bis(2,4,6‐trimethyl benzoyl) phosphine oxide (BAPO) on the properties of the foam shell were investigated by transmission electron microscopy, scanning electron microscopy, and nitrogen sorption measurements. Significant differences in the mechanical properties and porous features were obtained for different BAPO concentrations. The surface areas of the foam shells decreased, and the densities of the foam shells increased with increasing BAPO concentration. In addition, the nonconcentricity and out‐of‐roundness values were mainly less than 7 and 3%, respectively, for most of the shells. The results indicate that the PDVB hollow foam shells are a promising inertial fusion energy target. © 2014 Wiley Periodicals, Inc. J. Appl. Polym. Sci. 2015, 132, 41625.