Abstract
In the engineering validation and engineering design activities (EVEDA) on the International Fusion Materials Irradiation Facility (IFMIF), hydraulic stability of a liquid Li jet simulating the IFMIF Li target is to be validated in the EVEDA Li test loop (ELTL). This paper presents the fabrication and performance test results of a new contact-type liquid level sensor designed for use in ELTL. The sensor is to be utilized to measure variation of jet thickness in the validation test on hydraulic stability of the Li jet, which is one of the major key tests to be performed in ELTL. A fundamental requirement for the engineering specification of the sensor is to ensure the positioning precision of the measurement probe against the pressure load of approx. 0.1MPa between the inside and the outside of the test chamber. The positioning resolution of 0.1mm and precision of 0.01mm with respect to the fluid-depth direction are the most important design requirement. The sensor was successfully fabricated as designed. The performance tests performed after fabrication shows that the sensor satisfies the design specification.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
