Abstract
This experimental research aims to produce and study the properties of MoSi2 reinforced with CNT composites using the SPS sintering method. First and before any laboratory operations, using the Minitab 14 software, experimental samples were designed under L16 arrays. Four levels were set for defining parameters, such as the amount of reinforcing phase (CNT), sintering temperature (°C), and holding time (T). XRD, FESEM, density, micro-hardness, bending strength, and fracture toughness tests were used in the study for in-depth investigations. According to the signal-to-noise analysis, the parameter with the greatest influence is the reinforcement rate. Based on the obtained results, the composite with 5 wt% of carbon nanotubes, a sintering temperature of 1300 °C, and a holding time of 10 min was found to have the highest results.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
