Fabrication and Characterization of Titanium Borides by Electron Beam Surface Alloying

Abstract

This study shows the possibility of the fabrication of titanium borides by an alloying of a titanium substrate with boron powder via a scanning electron beam. During the electron beam alloying experiments, the speed movement of the specimens was varied, where it was 4 and 6 mm/s. The thickness of the alloyed zone formed by the lower velocity of the movement of the workpiece is greater than that of the coating obtained by the higher speed movement. The phase composition of the coatings is in the form of the TiB2 phase, as well as some amount of undissolved boron in both considered cases. In the case of the lower speed of the movement of the sample, the undissolved boron is within the whole volume of the alloyed zone, while at the higher speed movement, it is on the top of the specimen. The hardness of the obtained coatings by the higher speed of the specimen movement reached values of about 4500 HV. Considering the values of the surface alloy fabricated via the lower velocity movement of 4 mm/s, it is about 2500 HV, which is lower than that of the one obtained by the 6 mm/s speed of the sample movement. The result obtained for the friction coefficient (COF) for the specimen alloyed by the speed of the specimen motion of 4 mm/s is 0.40; the value for the coating obtained at a speed movement of 6 mm/s is 0.34. In both cases, these values are lower than that of the titanium substrate.