Abstract
The fabrication of solid-state nanopores using the electron beam of a transmission electron microscope (TEM) has been reported in the past. Here, we report a similar method to fabricate solid-state nanopores using the electron source of a conventional field-emission scanning electron microscope (FESEM) instead. Micromachining was used to create initial pore diameters between 50nm and 200nm, and controlled pore shrinking to sub 10nm diameters was performed subsequently during in situ processing in the FESEM. Noticeably, different shrinking behavior was observed when using irradiation from the electron source of the FESEM than the TEM. Unlike previous reports of TEM mediated pore shrinkage, the mechanism of pore shrinkage when using the FESEM could be a result of surface defects generated by radiolysis and subsequent motion of silicon atoms to the pore periphery.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.