Abstract
Photocatalyst coatings on alumina (Al2O3) balls had been successfully fabricated by mechanical coating technique, with titanium carbide (TiC) powder and subsequent heat treatment in carbon powder. The effect of heat treatment conditions in carbon powder on the formed compounds, surface morphology and photocatalytic activity of photocatalyst coatings was investigated. XRD results show that the formed compounds change with increasing the heat treatment temperature in carbon powder, and rutile TiO2 on the surface of TiC coatings at 1073 K and 1173 K. The generated oxygen vacancies confirmed by XPS measurement, are in favor of narrowing band gap to enhance the visible-light photocatalytic activity of photocatalyst coatings. The photocatalytic activity of photocatalyst coatings has been effectively enhanced, and the samples fabricated at 1073 K and 1173 K for 2 h show higher activity. The fabrication strategy provides us a facile preparation procedure of visible-light responsive photocatalyst coatings.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
