Abstract
In this study, an oxygen–acetylene flame synthesis system was developed to fabricate nanocarbon-based nanofluids (NCBNFs) through a one-step synthesis method. Measured in liters per minute (LPM), the flame’s fuel flows combined oxygen and acetylene at four ratios: 1.5/2.5 (P1), 1.0/2.5 (P2), 0.5/2.5 (P3), and 0/2.5 (P4). The flow rate of cooling water (base fluid) was fixed at 1.2 LPM to produce different nanocarbon-based materials (NCBMs) and various concentrations of NCBNFs. Tests and analyses were conducted for determining the morphology of NCBMs, NCBM material, optical characteristics, the production rate, suspension performance, average particle size, zeta potential, and other relevant basic characteristics of NCBNFs to understand the characteristics and materials of NCBNFs produced through different process parameters (P1–P4). The results revealed that the NCBMs mainly had flaky and spherical morphologies and the diameters of the spherical NCBMs measured approximately 20–30 nm. X-ray diffraction and Raman spectroscopy revealed that the NCBMs contained graphene oxide (GO) and amorphous carbon (AC) when the oxygen flow rate was lower than 1.0 LPM. In addition, the NCBMs contained reduced GO, crystalline graphite (graphite-2H), and AC when the oxygen flow rate was higher than 1.0 LPM. The process parameters of P1, P2, P3, and P4 resulted in NCBMs produced at concentrations of 0.010, 0.013, 0.040, and 0.023 wt%, respectively, in NCBNFs. All the NCBNFs exhibited non-Newtonian and shear-thinning rheological properties. The P4 ratio showed the highest enhancement rate of thermal conductivity for NCBNFs, at a rate 4.85 % higher than that of water.
Highlights
Nanofluids (NFs) are obtained by adding nanoparticles to conventional working fluids to form stable solid–liquid suspensions [1]
The nanocarbon-based materials (NCBMs) generated by higher temperatures produced different degrees of thermal reduction with the water mist, causing the hydroxyl, epoxy, and carboxyl groups in the internal layers of the graphene oxide (GO) to gradually disappear; GO was gradually reduced to RGO [29, 30]
The NCBMs in the present study should contain amorphous carbon (AC) because their XRD diffraction patterns were assigned after comparing the Joint Committee on Powder Diffraction Standards (JCPDS) peaks with the overall morphology
Summary
Nanofluids (NFs) are obtained by adding nanoparticles to conventional working fluids to form stable solid–liquid suspensions [1]. NFs can be used in many industries for improving system efficiency or for process improvements. Because NFs can be used to enhance the thermal properties of working fluids and the heat transfer efficiency of heat exchangers, many researchers have investigated NFs in depth, examining topics such as their manufacturing methods, basic characteristics (e.g., thermal conductivity, density, viscosity, specific heat, suspension capability), heat transfer behavior Nanoparticles (NPs) added to NFs have mostly been metal NPs (e.g., Cu, Ag, and Au) and oxide NPs (e.g., CuO, Al2O3, TiO2, SiO2, and ZnO). Oxide NFs have characteristics that are fairly stable, their thermal conductivity is low and cannot be
Sign-in/Register to view highlights & summary Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
