Abstract
We present a novel low-cost and batch fabrication method to fabricate a Fabry-Perot (FP) cavity with a micromechanical wet-etching process, through which FP cavities can be achieved with a cavity length of from several micrometers to tens of micrometers. The parallelism of mirror elements can be well achieved without electrostatic control. The quality of an etched surface can be greatly improved by the oxidation polish process. FP cavities with a finesse of approximately 50 are achieved. Analysis shows that the effective finesse is dominated mainly by the quality of the etched surface.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.