Fabricating capacitive micromachined ultrasonic transducers with wafer-bonding technology

Abstract

Introduces a new method for fabricating capacitive micromachined ultrasonic transducers (CMUTs) that uses a wafer bonding technique. The transducer membrane and cavity are defined on an SOI (silicon-on-insulator) wafer and on a prime wafer, respectively. Then, using silicon direct bonding in a vacuum environment, the two wafers are bonded together to form a transducer. This new technique, capable of fabricating large CMUTs, offers advantages over the traditionally micromachined CMUTs. First, forming a vacuum-sealed cavity is relatively easy since the wafer bonding is performed in a vacuum chamber. Second, this process enables better control over the gap height, making it possible to fabricate very small gaps (less than 0.1 /spl mu/m). Third, since the membrane is made of single crystal silicon, it is possible to predict and control the mechanical properties of the membrane to within 5%. Finally, the number of process steps involved in making a CMUT has been reduced from 22 to 15, shortening the device turn-around time. All of these advantages provide repeatable fabrication of CMUTs featuring predictable center frequency, bandwidth, and collapse voltage.