Abstract
Methods and the results of calculations for the pressure to cause end extrusion through perfectly smooth and rough wedge-shaped dies of small unequal angles are given and an examination is made of the effects on the pressure and obliquity of the emergent sheet of inclining the die orifice to the direction of the punch travel, using approximate methods.End extrusion through three holes of unequal size is considered for two different hypotheses and some calculated results are presented.Some cases of side extrusion through single and then two oppositely situated orifices are examined. Finally, a case of combined end and two side extrusions is considered.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
