Abstract
Systematic extrusion studies have been carried out on aluminium alloy 2124/SiCp metal matrix composites. Effects of various extrusion process parameters, such as die design, ram speed, extrusion ratio, reheat temperature, and lubrication, on the pressure requirement and surface quality of the as extruded circular rods have been investigated. Different volume fractions of SiC particles (10, 15, and 20 vol.-%) were used for the synthesis of metal matrix composite billets. These composites were synthesised using two different techniques, namely, stir casting and powder metallurgy. These billets were then hot extruded on a laboratory scale 500 ton vertical hydraulic press. The significance of specially designed dish shaped dies, avoiding the dead metal zone, has also been highlighted. The results indicated that the best extrusion was possible when powder metallurgical processed billets were extruded. Volume fraction analysis of ceramic reinforcement in the extruded rod (typically 2 m long) and in the extruded discard showed no appreciable backward migration of these particles during extrusion.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
