Abstract
AbstractPlastic profile die design is a complex task because of cross section area and shape changes occurring after die exit. Dimensions of the profile are increased by the extrudate swell phenomenon and decreased by drawdown and shrinkage. An experimental study on the effect of processing conditions on extrudate swell and on the shape of a rectangular profile was done for rigid poly(vinyl chloride), PVC, and high density polyethylene, HDPE, resins. Extrudate swell was found to be a strong decreasing function of residence time in the die and also, for short dies, of entrance geometry. For PVC, equilibrium swell increased with melt temperature. The differences in swelling for the two polymers are explained with the help of creep/recovery data obtained on a stress rheometer. Drawdown, die land length, and melt temperature were shown to have an important effect on the shape of a rectangular profile. Decreasing the die land and increasing the melt temperature had the effect of increasing preferably the thickness while drawdown, by inhibiting the swelling, decreased the thickness.
Sign-in/Register to access full text options 
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
